Measurement of nanometric deformation of thin membranes under controlled mechanical loads

Jobin, Marc (School of Engineering, Architecture and Landscape (hepia), HES-SO // University of Applied Sciences Western Switzerland) ; Sidorenko, Vladimir (School of Engineering, Architecture and Landscape (hepia), HES-SO // University of Applied Sciences Western Switzerland) ; Foschia, Raphael (School of Engineering, Architecture and Landscape (hepia), HES-SO // University of Applied Sciences Western Switzerland)

The accurate mechanical characterisation of thin membranes is recognized of prime importance for the development of membrane-based MEMS. To address this issue, we have built a measurement system which uses a nanoindentor to apply a well controlled force on one side of the membrane, while the deformation is recorded simultaneously on the other side with a home-made interferometric microscope. The use of a nanoindentor ensures a highly localised load on the membrane and the interferometric microscope allows us to measure deformations down to nanometric scale. The available forces enable deformations ranging from a few nanometers to membrane rupture. We have used optically transparent silicon nitride membrane up to 500nm thick The deformation is totally reversible without any measurable residual stress for loads up to 1000 uN. We measured rupture for loads ranging from 1600uN to 1700uN. The measured membrane spring constant at the center of the membrane is 169 N/m, close to the expected 140N/m given by the theory. The measured spring constant increases up to 301 N/m when the tip is brought close to a corner. Clear nanometric deformation of the membrane can be obtained under successive loads.


Keywords:
Conference Type:
short paper
Faculty:
Ingénierie et Architecture
School:
HEPIA - Genève
Institute:
inSTI - Institut des Sciences et Technologies industrielles
Publisher:
Boston, MA, USA, 1-5 June 2008
Date:
2008-06
Boston, MA, USA
1-5 June 2008
Pagination:
3 p.
Published in:
TechConnect Briefs ; Nanotechnology 2008: Materials, Fabrication, Particles, and Characterization – Technical Proceedings of the 2008 NSTI Nanotechnology Conference and Trade Show, 1-5 June 2008, Boston, MA, USA
Numeration (vol. no.):
2008, vol. 1, pp. 889-891
ISBN:
978-1-4200-8503-7
Appears in Collection:



 Record created 2020-04-24, last modified 2020-05-08

Fulltext:
Download fulltext
PDF

Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)