Organic solar cells improvement with quantum dots, up-converters and MoO3 hole transport layers

Jobin, Marc (School of Engineering, Architecture and Landscape (hepia), HES-SO // University of Applied Sciences Western Switzerland) ; Pellodi, Cédric (School of Engineering, Architecture and Landscape (hepia), HES-SO // University of Applied Sciences Western Switzerland)

We report on the power conversion efficiency (PCE) enhancement for organic solar cells (OSCs) based on several approaches. A standard cell composed of an indium tin oxide (ITO) anode, P3HT/ PCBM active layer, PEDOT:PSS hole transport layer and an aluminum cathode is used as a reference. We investigate the effects of the following three modifications. We first incorporate CdSe quantum dots (QDs) in the photo-optically active P3HT/PCBM blend in order to enhance the optical absorption. In opposite to other studies, QDs are not used here to replace the donor material (PCBM), and we always measured an enhanced PCE compared to the standard cell with a QDs:P3HTPCBM volume ratio up to 1:5. As a second modification, NaYF4:Yb,Er up conversion (UC) microcrystals are incorporated into a TiO2-x sol-gel to form an additional layer used to convert IR photons to blue and green photons. Again, OSCs with UC layer showed an improved PCE compared to the reference cell. The PCE enhancement is both attributed to the IR light absorption and to a better electron transport between the active layer and the cathode due to the electron transport layer capabilities of TiO2-x. Finally, MoO3 layer is used to replace the PEDOT:PSS layer as hole transport layer (HTL). This layer is deposed either by thermal evaporation or by spin coating from a sol-gel solution. We found evaporation better in terms of thickness control and reproducibility. It has been demonstrated that the PEDOT:PSS HTL can be replaced by MoO3, and the thickness of this MoO3 layer strongly affects the PCE of the cell. The maximum PCE was obtained with a thickness of 40nm, and again is better that the reference cell.


Type de conférence:
full paper
Faculté:
Ingénierie et Architecture
Ecole:
HEPIA - Genève
Institut:
inSTI - Institut des Sciences et Technologies industrielles
Adresse bibliogr.:
Brussels, Belgium, 14-17 April 2014
Date:
2014-04
Brussels, Belgium
14-17 April 2014
Pagination:
6 p.
Veröffentlicht in:
Photonics for Solar Energy Systems ; Proceedings of SPIE Photonics Europe, 14-17 April 2014, Brussels, Belgium
DOI:
ISSN:
0277-786X
Le document apparaît dans:

Note: The status of this file is: restricted


 Datensatz erzeugt am 2020-09-22, letzte Änderung am 2020-10-27

Fulltext:
Volltext herunterladen
PDF

Dieses Dokument bewerten:

Rate this document:
1
2
3
 
(Bisher nicht rezensiert)