The core layer is decisive : influence of the wall thickness in fiber-reinforced plastic components

Neuhaus, Didier (School of Engineering and Architecture (HEIA-FR), HES-SO // University of Applied Sciences Western Switzerland) ; Masserey, Bernard (School of Engineering and Architecture (HEIA-FR), HES-SO // University of Applied Sciences Western Switzerland) ; Bürgisser, Bruno (School of Engineering and Architecture (HEIA-FR), HES-SO // University of Applied Sciences Western Switzerland)

The mechanical properties of reinforced plastic components are not only influenced by the orientation of the fibers during the injection process but also by the wall thickness of the component. Rigidity deviations in a range up to 20% are ween with wall thicknesses of 1 to 4 mm. Comparing the results of numeric simulations and experimental tests sheds light on this issue.


Type d'article:
professionnel
Faculté:
Ingénierie et Architecture
Ecole:
HEIA-FR
Institut:
IRAP - Institut de recherche appliquée en plasturgie
SeSi - Institut de Systèmes d'ingénierie durables
Date:
2017-01
Pagination:
4 p.
Publié dans:
Kunststoffe International
Numérotation (vol. no.):
2017, vol. 107, no. 4, pp. 40-43
Ressource(s) externe(s):
Le document apparaît dans:

Note: The status of this file is: restricted


 Notice créée le 2020-11-03, modifiée le 2020-11-10

Fulltext:
Télécharger le document
PDF

Évaluer ce document:

Rate this document:
1
2
3
 
(Pas encore évalué)