Influence of rheology on part dimensions and production in injection molding

Dumont, Thierry (School of Engineering and Architecture (HEIA-FR), HES-SO // University of Applied Sciences Western Switzerland) ; Boéchat, Jean-Marc (School of Engineering and Architecture (HEIA-FR), HES-SO // University of Applied Sciences Western Switzerland)

The present work was conducted to assess the influence of polymer viscosity variation from batch to batch on the part dimensions and production interruptions. The results show however that parameters such as mold temperature, barrel temperature profile and holding pressure have much more influence on these two production quality indicators than the polymer viscosity.


Conference Type:
short paper
Faculty:
Ingénierie et Architecture
School:
HEIA-FR
Institute:
IRAP - Institut de recherche appliquée en plasturgie
Publisher:
Anaheim, CA, USA, 8-10 May 2017
Date:
2017-05
Anaheim, CA, USA
8-10 May 2017
Pagination:
4 p.
Published in:
Proceedings of ANTEC 2017, the plastics technology conference, 8-10 May 2017, Anaheim, CA, USA
Appears in Collection:

Note: The status of this file is: restricted


 Record created 2021-05-21, last modified 2021-05-28

Fulltext:
Download fulltext
PDF

Rate this document:

Rate this document:
1
2
3
 
(Not yet reviewed)